This page will showcase the build of our driveadragster rail job, a 160 inch nostalgia sling shot dragster
with a blown small block HEMI engine in it. We started with our base SFI 2.4 Certified frame that is our hottest selling chassis kit and will be building it into one of the coolest old school rails around. Plans are to run our new ChutePack body with the battery and cooling hidden from view to keep the car period looking. Check back often to see which manufacturers are involved with the build up and to see new photos.
bending the first tube
upper and lower rails in jig
rear and side diagonals in
front diagonal and upright
pod done ready for front tubes
front of pod
front on - welding torsion
getting welded in fixture
fitting cage
welding cage
more welds
finish welding cage
rear hung
motor trans and rear mocked up
welded frame ready for steering
mounting body
drill rear holes
rear hole and steering mocked up
drill and install chute bar mount
push bar and chute receiver
beginning of chute receiver
pushbar mounted inside
Battery lugs and shutoff
Corner shot of Stroud chute
Rear chute shot
Shot of Roller
Another roller shot
Motor with new stainless headers
Check back on a regular basis to watch the build progress online
